|
Tools: Flat head screwdriver
Philips head screwdriver
12 mm socket wrench.
Parts: CNC Aluminum Intake Adaptor
Air Filter
Air Filter Hose Clamp
Mounting Bracket
|
 |
STI/WRX Airbox Removal.
- Remove the MAF sensor by removing the 2 Philips head screws and unplugging the electrical connector.
- Loosen hose flat head hose clamp securing the airbox to the rubber corrugated intake hose.
- Remove the two 12 mm bolts securing the bottom of the airbox to the chassis.
- Remove the airbox by tugging slightly until the rubber grommet “pops” loose.
|
 |
TurboXS CNC “Shorty” Intake Installation:
- Bolt down the supplied TurboXS intake support bracket to the chassis with a 12mm bolt at the front mounting point where the airbox used to be.
|
 |
-
Mount the MAF sensor in the factory orientation into the TurboXS Billet “Shorty” intake with the two Philips head screws.
-
Mount the MAF sensor in the factory orientation into the TurboXS Billet “Shorty” intake with the two Philips head screws.
-
Mount the TurboXS intake assembly into the factory corrugated hose and secure the hose clamp.
-
Plug in the factory MAF sensor.
|
 |
| This is how the finished installation should look. |
 |
